Page 1 of 1

2012, 09/18: ProgenyES v8.8.6 Available

PostPosted: September 18th, 2012, 4:29 pm
by [TDR] Ross Hammer
A new certified release of ProgenyES, v8.8.6, is available via customer login to the ProgenyES website. A full Progeny Setup (includes new tutorials) as well as a reduced size Setup for Web (no tutorials) are available for immediate download. Note that a valid license must be already installed or installed separately to enable the software.

Key Updates in this Release:

- At-a-Glance Report Building: Though there have been a number of small improvements and additions to Progeny, the single most important change in this update is a redesigned Report Builder to streamline report construction. The filters, report output columns, and the sort options are all in the same view now, and field selections may be dragged between them for faster report building. Help mouse-overs have been added to assist with learning the new layout and new tutorials are available via the Help – Tutorials menu.


Note to ID Works Users: Significant changes were made between 8.5 and 8.8, which will require an update to your card project. It is recommended to transition to using the integrated Progeny ID system, which TDR staff can assist with at no additional cost (for the first two cards). If you have an Olympus camera or a Datacard signature pad, you will likely need to get a new camera or signature capture pad.

2012, 10/02: Update for v8.8.6 Available

PostPosted: October 17th, 2012, 4:47 pm
by [TDR] Ross Hammer
The original release of v8.8.6 was Build 9. We have since made available a minor update, v8.8.6 Build 10, to resolve an issue with the Report Builder filter for Living that was discovered post-release. To obtain the update, log into the ProgenyES.com website with your customer account and select the ProgenyES v8.8 Downloads section. The update is less than a megabyte in size and takes only a moment to install. We apologize for any inconvenience.